Suggestions for Operation of the Solar Fountain Pump：

1.Remove the film covering the solar panel before use.

2.Make sure there is no leaf or anything else shading any part of the solar panel.

3.Make sure the pump has enough sunshine (recommended in the midday sun).

4.First pull out the plug (the head part) and let the pump run for a few seconds to allow the air to escape from the pump.

5.Then plug in the connector to check if it works well.

6.Clean the pump regularly.

7.Do not let the pump work without water for a long time， otherwise its service life will be shortened.

8.Due to this pump is powered by direct sunlight; the height of the water spray depends on the strength of the sunlight.

Note:lt many not work well under the following situations.

• The solar fountain in the shadow
  
• The pump is jammed by debris
  
• The water level is too low
  
• The solar panel is blocked
  

Specification

• The power of the sun panel：7V 3.5W
• The size of the sun panel：Ø 180mm
• Pump power：7V 1.5W
• The maximum delivery head of pump：150CM
• Maximum water jet height：80CM
• Lifespan: ≥10000 hours
• Delay: ≤3s
• Water depth: The minimum water depth in the well should be 2.5 cm