Some items are no longer available. Your cart has been updated.
This discount code cannot be used in conjunction with other promotional or discounted offer.
Sale price USD $59.90 Regular price
OR
1. Install the water inlet valve
Clean the ground and dry the water before installation. Mark the central lines of the draining outlet, and install the inlet valve on the wall.
2. Mark the curve of ceramics
Align the drain hole of ceramic with the central line (there are two dimensions, 305mm and 400mm). mark the curve of ceramics for later installation.
3.Sealing ring installation
①Gently tilt the toilet sideways until it rests on the side surface.
②Install the sealing ring evenly along the outlet, and the small end of the sealing ring facing the toilet
4.Toilet (ceramic) installation
Lift the toilet, take the floor drain as a reference, align the ceramic body of the toilet with the ceramic contour line drawn on the ground, and slowly put the ceramic on the ground so that the two marks overlap. After overlapping, press the ceramic down (can be pressed by the weight of the human body) so that the sealing ring fully contacts the ground.
※Do not move the ceramic or shake it left and right after the marks are overlapped, otherwise the seal produced by the sealing ring may be damaged and cause water leakage.
5. Connection of water inlet valve
Connect the water inlet braided pipe to the water inlet angle valve; if the water pressure is high, you can install a water-saving piece or adjust the position of the angle valve to achieve the best flushing effect
NOTE:
If the water pressure is less than 0.24Mpa(static pressure), remove the water-saving tablets
Comment